Wallpaper for printing Digi Green on non-woven

 

Specifications

Basis: woven.

Density: 150 (+/- 10) g/m².

Total density: 175 (+/- 15) g/m².

Roll width: 106,7 cm.

Roll length: 50 m.

Plating: white.

Texture: 16601 smooth (smooth surface) / 16602 sand (sand).

Printing: eco-solvent, lite-solvent , latex, UV inks.

Application: indoors.

Manufacture: Holland.

Application

White wallpaper, specially designed for digital printing without the use of PVC. The material is produced on the nonwoven (non-woven), covered with acrylic layer. Due to the absence of polyvinyl chloride in the composition, Wallpaper DigiGreen can rightly be classified as "green" (environmentally friendly) material.

Use

With digital print on the Wallpaper, it is recommended to use cotton gloves, to avoid contamination of the surface of the printed material. Before printing it is also recommended to make a test print of the file with profiling (the settings of the printing equipment and software for printing on a particular type of material).

After printing the photo with the finished image must be left in straightened condition on a flat, clean and dry the vertical surface to complete the ink is dry (recommended 24 hours). The installation of Wallpaper on a paper basis is similar to installation of standard vinyl Wallpaper.

During installation use glue for heavy vinyl Wallpaper, Wallpaper impregnated with the adhesive for 10 minutes, after which you can apply them on pre-primed wall. The recommended way stickers Wallpaper – "lap" (2.5 - 5 cm), perhaps a sticker in the intersection of subject trimming the edges. When wallpapering overlap additionally promazyvaya bead (the edge of fabric) to complete bonding the abutting edges. To smooth cloth, use a roller or a rag of soft material. Prikatyvaet neat joints and smooth cloth without damaging the print layer (paint).

Close