Self-adhesive film series 9300

 

Characteristics

F 1
Thickness* (without protective paper and adhesive)

after 10 min. : 23,0 MCD /m2
after 60 min. of 3.0 MCD /m2

The decay time* (DIN 67510: 2008-02)
340 min (0,3 MCD/m2 )
Thickness* (without protective paper and adhesive)
0,150 mm
Weight* (without protective paper and adhesive)
230 g/m2
Dimensional stability (FINAT TM 14)
Adhered to steel shrinkage 0.3 mm max.
Temperature resistance***
Adhered to aluminium, -40° C to +100° C, without changes
Flammability (DIN 53438 T3)
Adhesive force*, (FINAT-TM1 after 24 hours, stainless steel)
18 H/25mm
Tensile strength (DIN EN ISO 527)

In the longitudinal direction: 12 MPa min.
In the transverse direction: 10 MPa min.

Elongation at break (DIN EN ISO 527)

In the longitudinal direction: min. 100 %

In the transverse direction: min. 100 %

Shelf life**
2 years
Bonding temperature
> +8° C

Lifetime when properly processed

Under vertical outdoor exposure (normal climate of Central Europe)

5 years (without printing, internal use)
* average ** in original packaging, at 20°C and 50% relative humidity *** normal climate of Central Europe.

Description

Three-layered, light yellow, does not contain cadmium polihlorvinilovye special film with a smooth surface according to DIN 67 510. The phosphorescent effect is especially high initial brightness immediately after turning off the exciting light source. Exciting action can be performed with any frequency, without reducing the luminescent properties of the film. The material does not contain any radioactive substances!!

The substrate

Special polyester film, 0,168 mm.

Glue

Polyacrylate adhesive is a solvent-based, providing permanent adhesion.

Application

Marking of evacuation routes and zones hazardous for internal use.

Printing method

Recommended screen printing.

Comment

The basis on which the gluing must be free from dust, grease and other contaminants that can adversely affect the bond strength of the material. When printing, the ink should be dried and cured completely. To determine the compatibility be applied must be thoroughly tested with provided paints. In addition, you should take into account the recommendations of the processing of the material. The batch traceability according to ISO 9001 is done on the basis of the roll number.

Colors

ATTENTION! The colors on your monitor may vary from actual!

Close