Plastisol Liquid Gold dye with the effect of liquid gold for printing on textiles

 

 

Description


Liquid Gold it is a coating plastisol paint with a characteristic gold luster. Can be used for flat printing and for the creation of a high layer. The paint is ready to use, but adding to it a PC (pigment concentrate) to achieve the effect of colored metallics.

 

Print options


Types of fabrics

100% cotton, blended fabric.

Mesh selection

34-49 threads/cm, depending on the type of printing.

Recommended tension: 25-35 N/cm.

The choice of the doctor blade

Hardness: 65-75 Sh single-layer, three-layer 65/90/65 Sh.

Edge: sharp.

Speed: medium to high.

Stencil

Emulsion: 2+2.

Capillary film: up to 400 microns.

Printed gap: 2 mm.

The drying parameters

Intermediate drying: 105 °C (220°F).

Transfer: 160 °C (320°F).

Supplements

Supplements: PC - max. 10% by weight.

Thinner: Viscosity Buster/Curable Reducer - max. 3% by weight.

Excessive dilution may reduce the resistance to migration and cause problems with intermediate drying and curing.

Storage

Store at temperature 18-32º C.

Avoid contact with direct sunlight.

To use during the year of receipt.

 

Features


• Shiny gold.

• The best results are achieved when printing on dark fabrics.

• Paint is ready to use.

• Create special metallic effects by adding up to 10% pigment of the desired color by weight.

• When washing in cold water, saves the brightness of colors and has good stability.

• Flexible, has excellent stretching ability.

• Can be used in combination with other products from First Base to create original special effects.

 

Printing guidelines


• Liquid gold can be printed on pre-dried inks.

• RS (concentrates of pigments) may be added in Liquid Gold for the production of non-ferrous metallics. Adding standard hues, you can achieve a more matte appearance of the print.

• The amount of additives in the paint for PC should not exceed 10% by weight.

• When added to the finished paint concentrate of pigment increases the color saturation.

• Printing technique: print-intermediate drying-printing.

 

Special recommendation


• Test for drying are required prior to beginning the print run. Insufficient or excessive drying will result in poor stability of the print to wash, and poor adhesion of paint. The temperature on the surface of the impression with intermediate and final drying must be monitored with a pyrometer or other means.

• Responsibility for the correct selection of paint to a printing material lying on the technologist or the printer responsible for making paint and printing options.

• Test before launch into production. Improper drying of the paint may cause poor resistance to washing, insufficient adhesion, unacceptable durability and increased likelihood of dye migration.

• Stir the product before printing.

• The printed image cannot be subjected to dry cleaning, bleaching, and Ironing with a hot iron.

• Avoid reducing the saturation of colors, the wash cloth should be held in cold water.

• For any application not referred in this manual, necessary to carry out preliminary tests or to consult a specialist.

Close