Ready plastisol inks Glitter PFX effect with glittery sequin


Ready glittery plastisol inks Glitter PFX designed for printing special effect glittery sequins. Glittery paints do not contain phthalates. Glittery dye used in printing for decoration design elements, and as separate colors. Plastisol paint Silver Glitter and Gold Glitter are specially designed for maximum opacity when printing on dark textiles, and also have excellent washability.


Color palette


Print options

Types of fabrics

100% cotton and blended fabrics on its basis, some types of synthetics.

Mesh selection

9-15 threads/cm.

Recommended tension: 25-35 N/cm.

The choice of the doctor blade

Stiffness: sandwich 65/90/65 Sh.

Profile: rectangular.

Edge: rounded.

Speed: average.


Emulsion: 2+2.

Capillary film: 50-70 microns.

Printed gap: 2 mm.

The drying parameters

Intermediate drying at 105 °C (220 °F).

Final drying: 160 °C (320 °F).


Additive: MX, PC - max. 1% by weight.

Thickener: 10025VB QEC Viscosity Buster - 3% by weight.


Store at temperature 18-32º C.

Avoid contact with direct sunlight.

To use during the year of receipt.



• Specially designed for expressive finishing design elements.

• For light or dark textiles. The best way is to dark.

• Excellent printing properties and elasticity.

• Does not tarnish in the wash.


Printing guidelines

• For best results, follow the recommended printing parameters.

• If possible, choose a mesh with a minimum diameter of the filament to increase the size of the open cells.

• In addition to printing, it is also possible to transfer the transfer glittery paint with the use of paper for cold offices. The temperature of the transfer 191°C (375 °F).

• Avoid excessive pressure on the squeegee during printing.

• Special attention should be paid to adequate filling of grid cells with irrigation (watering) of the stencil of for-squeegee before each printing cycle.

• Due to the reflectivity of metallic paint and a fairly thick layer after printing, you need to carefully select the drying mode.

• Use well-strained shape to optimize the printing process.


Special recommendation

• Pre-test drying are required prior to beginning the print run. Insufficient or excessive drying will result in poor stability of the print to wash, and poor adhesion of paint. The temperature on the surface of the impression with intermediate and final drying must be monitored with a pyrometer or other means.

• Responsibility for the correct selection of paint to a printing material lying on the technologist or the printer responsible for making paint and printing options.

• Before printing the paint should be stirred.

• Avoid excessive intermediate drying, as this may result in poor adhesion of paint layers when multi-color printing.

• Sealed image can not be subjected to dry cleaning, bleaching, and Ironing with a hot iron.

• For any application not referred in this manual, necessary to carry out preliminary tests or to consult a specialist.