An additive to plastisol inks FlexiPuff to achieve the effect of raising

   

 

Description


FlexiPuff created as a Supplement to the main series of colors to achieve the effect of uplift. Flexipuff can be added to paint in amounts up to 30% by weight. Flexipuff of interest to small businesses, which are awkward to store in a warehouse the full list of special paints to puff. Supplement Flexipuff Extra gives more level raising than Flexipuff. In any case, with the above additives will not be able to achieve such a result, as the use of special series NuPuff.

 

Print options


Types of fabrics

100% cotton, blended fabric based on cotton.

Mesh selection

24-77 threads/cm.

Recommended tension: 25-35 N/cm.

The choice of the doctor blade

Hardness: single-layer 65-85 Sh, Sh sandwich 75/90/75.

Profile: rectangular.

Edge: rounded.

Speed: from slow to average.

Stencil

Emulsion: 2+2.

Capillary film: not applicable.

Printed gap: 2 mm.

The drying parameters

Intermediate drying: 70 °C (160 °F).

Transfer: 160°C (320 °F).

Supplements

Supplements: 10150 Finesse can be used to reduce the degree of rise of the puff without changing paint viscosity.

Diluent: 10070 Curable Reducer up to 10% by weight.

Storage

Store at temperature 18-32º C.

Avoid contact with direct sunlight.

To use during the year of receipt.

 

Features


• Helps to create an interesting relief prints.

• High resistance to wear.

• No flaking.

 

Printing guidelines


• You can get different effects by changing the temperature of the intermediate drying, the thickness of the emulsion layer on the stencil, and adictiva standard colors and special effects.

• When printing multiple colors, it is necessary to dry the puff before printing the other colors.

• This paint is designed with special protection from fraying, therefore, the risk that the cured paint will break down is minimized.

• 10520 Flexipuff Additive can be added to a standard paint (Epic series Standard, MX), to obtain a raised seal. Please note that adding this product does not give relief of such height as NuPUFF.

 

Special recommendation


• Test for drying are required prior to beginning the print run. Insufficient or excessive drying will result in poor stability of the print to wash, and poor adhesion of paint. The temperature on the surface of the impression with intermediate and final drying must be monitored with a pyrometer or other means.

• Responsibility for the correct selection of paint to a printing material lying on the technologist or the printer responsible for making paint and printing options.

• Before printing the paint should be stirred.

• Sealed image can not be subjected to dry cleaning, bleaching, and Ironing with a hot iron.

• For any application not referred in this manual, necessary to carry out preliminary tests or to consult a specialist.

Close