Self-adhesive film for continuous wrapping of cars 3951

 

Specifications

Basis: PVC.

Thickness: 55 µm.

Type of substrate: silicone paper with double-sided polyethylene coating, 145 g/m².

Type of glue: polyacrylate adhesive, solvent-based, repositionable, permanent final adhesion, grey and transparent.

Gluing temperature: +8°C.

Roll width: 137, 152 cm.

Roll length: 25, 50 m.

Surface: transparent, white, glossy.

Printing: solvent, latex, UV inks.

Application: full-color printing and subsequent pasting of cars.

Service life: 10 years (white), 8 years (transparent); "HT" - 7 years (white) 5 years (transparent).

Manufacture: Germany.

Application

Self-adhesive, cast PVC-film for continuous wrapping of cars. Car film white and transparent designed for full color printing and can be used for full or partial color change of the car body, be applied to complex curved parts such as bumpers, mirrors, door handles.

Clear film without overprinting can be used for protective wrapping of the car (front bumper). Avtovinil has a repositionable type adhesive that makes it easy to position the graphic in the process of gluing. High stability and dimensional stability of the film allow you to paste over the curved and uneven surface over the seams and recesses.

Film 3951 with a marking of "RA" is made on technology "RapidAir®", which allows quickly and exactly to paste the large image on the car surface without bubbles. The inclusion of air can be easily removed from under the film by stroking.

Film 3951 marked "HT" specifically designed for bonding to "difficult" a rough or structured surface as well as on low energy plastic materials (polyethylene, polypropylene). Has a permanent, unmovable type of glue.

Car film designed for wide format solvent printing, and UV printing and latex inks. Suitable for prolonged outdoor use. For additional protection of the film from fading and mechanical damage it is recommended to use protective laminates.

Use

Digital print on self-adhesive film, it is recommended to use cotton gloves, to avoid contamination of the surface of the printed material. Before printing it is also recommended to make a test print of the file with profiling (the settings of the printing equipment and software for printing on a particular type of material).

After printing self-adhesive film with a ready image needs to be left in the expanded position on a flat, clean and dry the vertical surface to complete the ink is dry (recommended 24 hours).

Prior to installation of the film is necessary to clean the car surface with special cleaners. The ideal temperature for installation of self-adhesive film of 20-22°C. the Ideal temperature of dismantling film 19°C, with the dismantling of the street in the cold season it is recommended to use a hot blowout.

To ensure a longer service life of the film is recommended to laminate the finished print. Lamination allows to give the image a glossy sheen, and to preserve color depth and to protect the product from moisture and damage, greatly prolonging its service life.

Close