Color pigments Epic PC (Express Color Matching) to obtain shades of Pantone's


Epic PC is a simple system of mixing is presented of the 15 color concentrates that make it easy to mix desired colors for the Pantone system, and get ready basic shades. The resulting paints can produce high-speed printing, including "wet on wet". After drying, the prints are very soft to the touch, have a matte appearance and excellent abrasion resistance.


Color palette


Print options

Types of fabrics

100% cotton and blended fabrics on its basis, some types of synthetics.

Mesh selection

Rough print: 34-90 threads/cm.

Fine lines: 77-120 threads/cm.

Recommended tension: 25-35 N/cm.

The choice of the doctor blade

Hardness: single-layer 65-85 Sh, Sh sandwich 75/90/75.

Profile: rectangular.

Edge: sharp.

Speed: fast.


Emulsion: 2+2.

Capillary film: not applicable.

Printed gap: 2 mm.

The drying parameters

Intermediate drying: 70 °C (160 °F).

Final drying: 150 °C (300 °F).


Additive: 10150FNS Finesse - 10% by weight.

Thickener: 10025VB QEC Viscosity Buster - 3% by weight.


Store at temperature 18-32º C.

Avoid contact with direct sunlight.

To use during the year of receipt.



• Soft to the touch, the matte prints.

• Fast intermediate drying and minimal residual stickiness.

• All the colors of the developed technology Genesis, which gives excellent printing properties when printing "wet on wet".

• All paint is designed for high speed printing with outstanding resistance to clogging.


Printing guidelines

• For best results, follow the recommended printing parameters and the number of grids.

• Paints are not opaque. With proper mixing (following the formulas), you get the color light to medium opacity.

• Best results are obtained when printing on white/light fabrics.

• When printing on dark textiles may require the printing substrate. On 100% cotton fabrics recommended 11335WHT Sprint White or 11135WHT Olympia Plus White.

• To avoid the risk of migration of the dyes fabrics when printing on materials where migration is possible, the print substrate recommended 11003WHT Single LC White.

• Avoid excessive pressure on the squeegee during printing.


Special recommendation

• Test for drying are required prior to beginning the print run. Insufficient or excessive drying will result in poor stability of the print to wash, and poor adhesion of paint. The temperature on the surface of the impression with intermediate and final drying must be monitored with a pyrometer or other means.

• Responsibility for the correct selection of paint to a printing material lying on the technologist or the printer responsible for making paint and printing options.

• To verify compliance of shades, all the paint mixed according to the formulas Pantone that was printed through the mesh 62 threads/cm on fabric 100% cotton white color. However, the color PC you can also print through meshes from 43 to 120 threads/cm, depending on the selected mesh and the resulting paint layer can change the color saturation and opacity of paint.

• Avoid excessive intermediate drying, as this may result in poor adhesion of paint layers when multi-color printing.

• Excessive dilution can dramatically decrease the opacity of the paint.

• Before printing the paint should be stirred.

• Sealed image can not be subjected to dry cleaning, bleaching, and Ironing with a hot iron.

• For any application not referred in this manual, necessary to carry out preliminary tests or to consult a specialist.